Studio Technologies Model 342 Intercom Station is prepared for professional supply, replacement, integration, or project procurement use. Key factual specifications include Network and AoIP: Type: Dante
Studio Technologies Model 342 Intercom Station is prepared for professional supply, replacement, integration, or project procurement use. Key factual specifications include Network and AoIP: Type: Dante Audio-over-Ethernet AES67-2013 Support: Yes, Selectable On/Off Dante Domain Manager (DDM) Support: Yes Bit Depth: Up to 24 Sample Rate: 48 kHz Pull-Up/Down Support: No Dante Transmitter (Output) Channels: 2 Dante Receiver (Input) Channels: 2 Dante Audio Flows: 4; 2 Transmitter, 2 Receiver; Network Interface: Type: 100BASE-TX, Fast Ethernet per IEEE 802.3u (10BASE-T and 1000BASE-T (GbE) Not Supported) Data Rate: 100 Mb/s (10 Mb/s and 1000 Mb/s GbE Ethernet Not Supported); Headset Compatibility: Headset A: Single- or Dual-Ear Broadcast-Style with Dynamic or Electret (Low-Voltage DC-Powered) Microphone: Pin 1 Mic Common; Pin 2 Mic; Pin 3 Phones Common; Pin 4 Phones Left; Pin 5 Phones Right Headset B: CTIA/AHJ Configuration (Typically Uses Electret Powered Mic): Tip Phones Left; Ring 1 Phones Right; Ring 2 Common; Sleeve Mic; Audio Channel: 1 Talk, 2 Listen; Microphone Input: Compatibility: Dynamic or Electret (Low-Voltage DC-Powered) Microphones Type: Unbalanced Electret Microphone Power: 3.3 Volts DC via 2 Kilohms Resistor, Selectable On/Off Impedance: 1 Kilohms, Nominal, Microphone Power Off; 690 Ohms, Nominal, Microphone Power On Gain: 24, 30, 36, 42, or 48 dB, Selectable, Ref. -60 dBu Input to Dante Output (-20 dBFS Nominal) Frequency Response: 40 Hz to 20 kHz, -3 dB Distortion (THD+N): <0.02% (at Minimum Gain) Dynamic Range: 91 dB of Dynamic Range.
Compatibility, quantity, lead time, shipping, and final project requirements should be confirmed before purchase.
Specifications
Audio Channel
1 Talk, 2 Listen
Box Dimensions (LxWxH)
8.9 x 7.9 x 3.9"
Call Functions
Implementation: Monitors Both Dante Receiver (Input) Channels for Presence of Call Signals Signaling Method: 20 kHz, ±800 Hz, within Audio Channels Call Receive Level: -27 dBFS Minimum
Compressor
Application: Applies to Dante Transmitter (Output) Channel and Sidetone Audio Threshold: 1 dB Above Nominal Level (-19 dBFS) Slope: 2:1 Status LED: Lights When Compressor Active
Configuration
Uses Studio Technologies' STcontroller Personal Computer Application
Connectors
Headset A: 5-Pin Female XLR Headset B: 4-Conductor (TRRS) 3.5 mm Jack, per Japanese Standard JEITA/EIAJ RC-5325A Ethernet: Neutrik NE8FBH etherCON RJ45 Jack USB: Type-A Receptacle (Located Inside Model 342's Enclosure and Used Only for Application Firmware Updates)
Dimensions (W x H x D)
4.3 x 2.1 x 5.1" / 10.9 x 5.3 x 13.0 cm
Environmental
Operating Temperature: 32 to 122°F / 0 to 50°C Storage Temperature: -40 to 158°F / -40 to 70°C Humidity: 5 to 95%, Non-Condensing Altitude: Not Characterized
Headphone Output
Type: 2-Channel Compatibility: Intended for Connection to Stereo (Dual-Channel) or Monaural (Single-Channel) Headsets with Nominal Impedance of 50 Ohms or Greater Maximum Output Voltage: 2.8 Vrms, 1 kHz, 150 Ohm Load Frequency Response: 20 Hz to 10 kHz, -3 dB Distortion (THD+N): <0.002% Dynamic Range: >100 dB
Headset Compatibility
Headset A: Single- or Dual-Ear Broadcast-Style with Dynamic or Electret (Low-Voltage DC-Powered) Microphone: Pin 1 Mic Common; Pin 2 Mic; Pin 3 Phones Common; Pin 4 Phones Left; Pin 5 Phones Right Headset B: CTIA/AHJ Configuration (Typically Uses Electret Powered Mic): Tip Phones Left; Ring 1 Phones Right; Ring 2 Common; Sleeve Mic
Microphone Input
Compatibility: Dynamic or Electret (Low-Voltage DC-Powered) Microphones Type: Unbalanced Electret Microphone Power: 3.3 Volts DC via 2 Kilohms Resistor, Selectable On/Off Impedance: 1 Kilohms, Nominal, Microphone Power Off; 690 Ohms, Nominal, Microphone Power On Gain: 24, 30, 36, 42, or 48 dB, Selectable, Ref. -60 dBu Input to Dante Output (-20 dBFS Nominal) Frequency Response: 40 Hz to 20 kHz, -3 dB Distortion (THD+N): <0.02% (at Minimum Gain) Dynamic Range: 91 dB of Dynamic Range
Network Interface
Type: 100BASE-TX, Fast Ethernet per IEEE 802.3u (10BASE-T and 1000BASE-T (GbE) Not Supported) Data Rate: 100 Mb/s (10 Mb/s and 1000 Mb/s GbE Ethernet Not Supported)
